Smeg GKC641-3 사용자 설명서

다운로드
페이지 18
 
Instructions for the installer
 
 
 
 
27 
4.  GAS CONNECTION 
 
Connection to the gas mains may be made with a rigid copper pipe or 
with a flexible pipe and conforming to the provisions defined by standard 
regulations in force.  
To facilitate connection, fitting A on the rear of the appliance may be 
adjusted laterally. For this purpose, loosen hexagon nut B, turn fitting A 
to the desired position, and retighten hexagon nut B (tightness is ensured 
by a biconical brass ring). Use a soapy solution to check for proper 
tightness. Never use a free flame.  
The hob has been inspected for G25 (2L 3B/P) at a pressure of 25 mbar. 
For use with other types of gases, see Section “5.  ADAPTATION TO 
DIFFERENT TYPES OF GAS”. The gas intake fitting is ½” gas externa

threaded (ISO 7-1). 
 
 
 
Connection with rigid copper pipe: 
the connection to the gas mains must 
not provoke stress of any kind on the 
hob.  
Connection may be made by using 
biconical adapter D with insertion of 
gasket C (supplied). 
 
 
 
Connection with flexible pipe: use 
only flexible pipes conforming to 
standard regulations in force, inserting 
gasket  C (supplied) between fitting A 
and flexible pipe E
 
 
 
 
 
 
 
 
The flexible pipe has to be installed so that pipe length does not exceed 
1.5 meters of maximum extension. Make sure that the pipes do not touch 
any moving parts or become damaged.