Vermont Casting LHER20 사용자 설명서

11

1.  The use of substitute glass will void all product 

warranties.

2.  Care must be taken to avoid breakage of the glass.  
3.  Under no circumstances should this appliance be 

operated without glass properly installed, or with any 
cracked or broken glass.  Replacement of any glass 
assembly as supplied by the manufacturer should be 
done by a licensed qualified service person.

To remove 
louvre, lift louvre 
up and then pull 
out.
(Fig. 16)  

It will be necessary to clean the glass periodically. 
During start-up condensation, which is normal, forms on 
the inside of the glass and causes lint, dust and other 
airborne particles cling to the glass surface. Also initial 
paint curing may deposit a slight film on the glass. It is 
therefore recommended that the glass be cleaned two 
or three times with a non-ammonia household cleaner 
and warm water (we recommend gas fireplace glass 
cleaner). After that the glass should be cleaned two or 
three times during each heating season depending on 
the circumstances present.

1.  Remove two (2) screws at the bottom of the frame. 

(Fig. 17)

2.  Lift up and unhook glass frame at the top.

1 . Remove glass frame. (See "Glass Removal" section)
2.  Remove logs from packaging.
3.  Place logs according to the model instructions be-

low:

LHEC20, LHER20 (Figs. 18)

a.  Place rear left log (JR7). Use the log's bottom 

holes to locate it onto one pin stud of the rear log 
bracket on the left and the other end of the log 
will sit on top of the lid of the left log support.

b.  Place rear right log (JR8). Use the log's bottom 

holes to locate it onto the two (2) pin studs of the 
rear log bracket on the right. 

c.  Place the front left log (JR9). Position the log 

notch against the second grate from the left, and 
the other edge of the log on top of the rear left log 
notch. Ensure the log is secure in place.

d.  Place the front right log (JR10). Position the log 

notch against the third grate from the right, and 
the other edge of the log on top of the rear right 
log notch. Ensure the log is secure in place.

e.  Place the burner lava rock on the front area of the 

burner housing. (Fig. 18)

LHEC30, LHER30 (Fig. 19)

a.  Place the rear center log (KR24). Use the log's 

bottom holes to locate it onto the two (2) pin studs 
of the rear log bracket on the center.

b.  Place rear left log (KR22). Use the log's bottom 

holes to locate it onto the two (2) pin studs of the 
rear log bracket on the left. 

c.  Place rear right log (KR23). Use the log's bottom 

holes to locate it onto the two (2) pin studs of the 
rear log bracket on the right.

d.  Place the front left log (KR25). Position the log 

notch against the second grate from the left, and 
the other edge of the log on top of the rear left log 
notch. Ensure the log is secure in place.

1.

2.

Louvre

Glass Panel

FP444

Fig. 16  Louvre removal.

FP1327

window frame removal

4/3/03   djt

Machine Screw

FP1353

Fig. 17  Remove glass frame.