Vermont Casting LHER20 사용자 설명서

12

Upon completing the gas line connec-
tion, a small amount of air will be in 
the lines. When first lighting unit with 
pilot light, it will take a few minutes 
to purge themselves of this air. Once 
the purging is complete, the pilot 
and burner will light and operate as 
indicated in the instruction manual. 
Subsequent lightings of the heater will 
not require such purging.
When lit for the first time, the appli-
ance will emit a slight odor for awhile. 
This is due to paint and lubricants 
used in the manufacturing process. 
After each lighting, vapor may con-
dense and fog the glass; this moisture 
disappears within a few minutes of 
burning.

For fireplaces equipped with HI/LO valves, flame 
adjustment is accomplished by rotating the HI/LO 
adjustment knob located near the center of the gas 
control. (Figs. 20 or 21)

LO

HI

Turn

counterclockwise

to decrease

flame height

Turn clockwise

to increase

flame height

HV102

Honeywell hi/lo knob

4/5/99   djt

Fig. 20  Flame adjustment knob for Honeywell Valve.

It is important to periodically perform 
a visual check of the pilot and the 
burner flames. Compare them to the 
Figure 22 and Figure 23 or 24. If any 
of the flames appear abnormal call a 
service person.

The large lava rock provided with this fireplace should 
be placed on the firebox base on either side of the 
burner assembly.

e.  Place the front right log (KR26). Position the log 

notch against the third grate from the right, and 
the other edge of the log on top of the rear right 
log notch. Ensure the log is secure in place.

f.  Place the burner lava rock on the front area of the 

burner housing. (Fig. 19)

LG286

LHEDV30 

Logs

4/03

KR22

KR25

KR24

KR23

KR26

Burner Lava 

Rock

Fig. 19   LHEC30 and LHER30 log and lava rock placement.

Front Grate

LG286

LG285

LHEDV20

logs

4/03

JR9

JR7

JR8

JR10

LG285

Burner Lava Rock

Fig. 18  LHEC20 and LHER20 log and lava rock placement.

Front Grate