Multiquip C30HDG 사용자 설명서
INSTALLATION/OPERATION MANUAL — REV. #0 (08/19/09) — PAGE 13
TROUBLESHOOTING
Troubleshooting
Table 2.
Symptom
Possible Problem
Solution
Transmitter does not
function at all
function at all
LED status indicator not
fl ashing.
fl ashing.
LED indicator not lit when
power ON/OFF switch is
pressed.
power ON/OFF switch is
pressed.
Turn transmitter power
switch ON.
switch ON.
Weak dead battery, replace
batteries.
batteries.
Check orientation of
batteries.
batteries.
Make sure transmitter has
be matched (paired) to
receiver.
be matched (paired) to
receiver.
Receiver is not powered
up.
up.
Transmitter range is poor
LED indicator not lit when
power ON/OFF switch is
pressed
power ON/OFF switch is
pressed
LED indicator lit when
switch is pressed
switch is pressed
Weak dead battery, replace
batteries.
batteries.
Check receiver antenna
Maintain line-of-sight
Avoid obstructions
Check for interference
Heavy rain reduces range
Avoid obstructions
Check for interference
Heavy rain reduces range
Transmitter works (RX LED
in receiver comes on) but
outputs do not operate
in receiver comes on) but
outputs do not operate
Check wiring.
Make sure output wires are
not shorted to Ground
not shorted to Ground
Verify load is wired
correctly.
correctly.