Standard Horizon MDS-9 사용자 설명서
Radar Installation Manual
Page 17
2. Move the ShuttlePoint knob to highlight ADVANCED SETUP and press [ENT].
3. Move the ShuttlePoint knob to highlight IN/OUT CONNECTIONS and press [ENT].
4. Move the ShuttlePoint knob to highlight PORT 1 INPUT and press [ENT].
5. Move the ShuttlePoint knob up/down to select RADAR and press [ENT].
6. Press [CLR] or move the ShuttlePoint knob to the left until the Chart page is shown.
3. Move the ShuttlePoint knob to highlight IN/OUT CONNECTIONS and press [ENT].
4. Move the ShuttlePoint knob to highlight PORT 1 INPUT and press [ENT].
5. Move the ShuttlePoint knob up/down to select RADAR and press [ENT].
6. Press [CLR] or move the ShuttlePoint knob to the left until the Chart page is shown.
2.7.1 CP300 & CP300i Connections
PWR & ACC 1 Cable
A switch MUST be connected
to turn the Radar On or Off
to turn the Radar On or Off
Radar
Switch
Battery
Battery Switch
RADAR CABLE
WIRE COL. FUNCTION
BLACK
BLACK
DATA GROUND
ORANGE
DATA OUT+
YELLOW
DATA OUT-
BROWN
DATA IN+
RED
DATA IN-
GREEN
POWER ON/OFF SWITCH
BLUE
POWER ON/OFF SWITCH
BLACK
RADAR BATTERY GROUND
WHITE
RADAR BATTERY POSITIVE
PLOTTER CABLE
WIRE COLOR
FUNCTION
GREEN
GND
No connection
AUX OUT+
(Port 1) OUTPUT+ (TX+)
BLUE (Port 1)
INPUT+ (RX+)
BLACK
POWER- /GND
RED
POWER+
BROWN
Breaker panel
Figure 2.7.1 - CP300 & CP300i Connections
Port Setup
When an optional Radar Antenna is connected, Port 1 of the NMEA In/Out Communication
Setup menu must be changed to RADAR as shown below for communications.
Setup menu must be changed to RADAR as shown below for communications.