Polycom SIP 2.2.0 사용자 설명서

 Configuring Your System

4 - 15

Configuration changes can performed centrally at the boot server:

The SoundPoint IP and SoundStation IP phones contain two Ethernet ports, 

labeled LAN and PC, and an embedded Ethernet switch that runs at full 

line-rate. The Ethernet switch allows a personal computer and other Ethernet 

devices to connect to the office LAN by daisy chaining through the phone, 

eliminating the need for a stand-alone hub. The SoundPoint IP switch gives 

higher transmit priority to packets originating in the phone. The phone can be 

powered through a local AC power adapter or can be line-powered (power 

supplied through the signaling or idle pairs of the LAN Ethernet cable). Line 

powering typically requires that the phone plugs directly into a dedicated 

LAN jack. Devices that do not require LAN power can then plug into the 

SoundPoint IP PC Ethernet port. 

To help ensure good voice quality, the Ethernet switch embedded in the 
SoundPoint IP phones should be configured to give voice traffic emanating 

from the phone higher transmit priority than those from a device connected to 

the PC port. If not using a VLAN (VLAN set to blank in the setup menu), this 

will automatically be the case. If using a VLAN, ensure that the 802.1p 

priorities for both default and real-time transport protocol (RTP) packet types 

are set to 2 or greater. Otherwise, these packets will compete equally with 

those from the PC port. For more information, refer to 

.

Configuration file: 
sip.cfg

To turn idle display animation on or off.

For more information, refer to 

 on page 

To replace the animation used for the idle display.

For more information, refer to 

page 

To change the position of the idle display animation.

For more information, refer to 

 on 

page