Mitsubishi Electronics C64 사용자 설명서

 

66 

After setting up the parameter (PR) listed in the table, turn off the NC power. To validate the 
parameter, turn on the power again. 

 

2001 rapid 

Rapid 
traverse 
feedrate 

Set up the rapid traverse feedrate for each axis.  The 
maximum value to be set differs with mechanical 
systems. 

1 to 1000000 
(mm/min) 

2002 clamp 

Cutting 
feedrate for 
clamp 
function 

Define the maximum cutting feedrate for each axis. 
Even if the feedrate in G01 exceeds this value‚ the 
clamp will be applied at this feedrate. 
 

1 to 1000000 
(mm/min) 

2003 

(PR) 

smgst Acceleration 

and deceler- 
ation modes 

Specify acceleration and deceleration control modes. 

OT3 OT2 OT1 C3

C1 LC R3

R1 LR 

F

E

D

C

B

A

9

8

7

6

5

4

3

2

1

0

 

(Note)  Set 0 in null bits. 
 
Rapid traverse feed acceleration and deceleration 
types 

LR: Linear acceleration/deceleration 
R1: Primary delay 
R3:  Exponential acceleration and linear 

deceleration 

(Note)  Designate “F” with bits 0 to 3 for rapid traverse 

with acceleration/deceleration by software. 
Note that the acceleration/deceleration by 
software will not applied on such case as 
follows; 

(1) When the parameters are set as “#1205 

G0bdcc” = “1” (acc/dec before G00 is 
valid) and “#1086 G0Intp” = “0” (G00 
non-interpolation invalid), the 
acceleration/deceleration before 
interpolation will be applied to the 
following operation. 

(a) Travel by G00 command 
(b) Travel from G28/G30 command start 

point to the intermediate point 

(c) Travel from G29 command reference 

to the intermediate point  

(Continued on the next page) 

Specify the modes 
in hexadecimal 
notation.