Maytag W10188238A 사용자 설명서

NOTE: To avoid possible damage to the work surface, cover the 
work surface.
1. Remove any remaining contents from the microwave oven 

cavity.

2. Remove the 2 screws that attach the mounting plate to the 

back of the microwave oven, then remove mounting plate and 
set aside.

3. Reattach the 2 screws.
4. Tape the microwave oven door closed so that door does not 

swing open while the microwave oven is being handled.

NOTE: To avoid damage to the microwave oven, do not grip or 
use the door or door handle while the microwave oven is being 
handled.

The microwave oven is set for recirculation installation. For wall or 
roof venting, changes must be made to the venting system.
NOTE: Skip this section if you are using recirculation installation. 
Keep the damper assembly in case the venting method is 
changed, or the microwave oven is reinstalled in another location 
where wall or roof venting may be used.

1. Remove damper plate screw and top blower motor screw 

attaching damper plate to top of microwave oven exterior. Lift 
up damper plate.

2. Remove the blower motor screw from the back of the 

microwave oven, then lift out blower motor.

3. Using diagonal wire cutting pliers, snip out the rear damper 

vent covers at the perforations.

4. Rotate blower motor 180° so that exhaust ports face the back 

of microwave oven, and lower blower motor back into the 
microwave oven.

5. Close damper plate, and reinsert top blower motor screw 

removed in Step 1.

A                           B

A                                                                         B

C

A

B

C

B

A

A

A                 B