Vermont Casting SDDVRBD 사용자 설명서

14

• 

#10 x 1/2” phillips screws, 6

• 

Control Knob

• 

Retainer Collar

• 

Snapstat 

 

•

  Snapstat Bracket

• 

Blower Assembly w/ Rheostat Control 

NOTE: The Rheostat Assembly and the Snapstat As-
sembly are not used on RF Models.
For RF Models only: Follow Step 3, then run the 
spliced female leads to the front of the stove and attach 
to PC board of RF valve. Then follow Step 5.
1. Attach the Snapstat to the Bracket using two #10 x  

1/2” phillips sheet metal screws as shown in Figure 
13.

2. Locate and remove the 1/4-20 x 3/8” hex head bolt 

installed in the hole in the right rear ledge of the 
firebox. (Fig. 13) Use that bolt to secure the Snapstat 
Bracket to the firebox. The mounting hole is slotted 
to allow you to adjust the bracket so that its head 
makes contact with the firebox surface. (Fig. 11)

3. Attach the Fan to the firebox by engaging the up-

per flange of the fan skirt under the lower edge of 
the  Shroud and secure the skirt with the four screws 
provided with the kit. (Fig. 14)

ST240

FDV attach fan

12/13/99   djt

Upper 

Flange

ST240

Fig. 14  The upper flange of the fan skirt should be located 
behind the lower edge of the shroud.

NOTE: Verify the two relief doors (located on top of 
the firebox) are properly seated on the gasket. The 
doors sit flush on the gasket, and should lift easily 
from the seal around the opening. 

ST240

FDV attach fan

12/13/99   djt

ST241

Fig. 15   Correct position of fan skirt installation.

4. The rheostat control switch attaches to the left side of 

the valve bracket at the front of the stove. (Fig. 16)

  •  Insert the switch box shaft through the hole in the 

back of the right side of the valve bracket, aligning 
the locator pin with the smaller hole in that bracket.
•  Attach the retaining nut to the switch control shaft 
to secure it to the plate.
•  Attach the Control Knob to the rheostat shaft.
•  Use the wire tie to secure the fan and rheostat 
wire harnesses together.

FK101b

Stardance RV

Install snapstat

6/07

1/4-20 x 3/8” 

Hex Head Bolt

Bracket

Snapstat

1/2” Sheet 

Metal Screws

FK101b

Fig. 13  Snapstat assembly and installation.

The stove is shipped fully assembled on its back. Un-
pack the stove and carefully set it upright.

Porcelain enamelled surfaces are fragile. Handle 
porcelain enamelled castings tenderly. Familiarize 
yourself with the assembly steps before you begin 
and proceed with deliberation and care. If possible, 
have assistance available.
Place enamelled castings on a soft, cushioned sur-
face until you are ready to assemble.
Avoid contact between the castings and other hard 
surfaces or objects.