Paradyne CSU 사용자 설명서
C. Router CLI Commands, Codes, and Designations
C-22
September
2002
9128-A2-GB20-80
[
no
]
ip
access-group
access-list-1-199num
[
in
|
out
]
Minimum Access Level: Administrator
Command Mode: config-if
Command Mode: config-if
Allows you to control access to an interface by allowing you to designate (or delete) a set
of access rules to be applied to either incoming or outgoing packets. By default, no access
lists are applied to interfaces.
of access rules to be applied to either incoming or outgoing packets. By default, no access
lists are applied to interfaces.
Example: ip access-group 17 in
NOTE: A user may specify that an access list is applied to either inbound packets,
outbound packets, or both inbound and outbound packets (two commands). If a
specified access list does not exist, all packets are passed.
outbound packets, or both inbound and outbound packets (two commands). If a
specified access list does not exist, all packets are passed.
access-list-1-199num – The access list number. The valid ranges for access lists are:
1– 99 – Standard IP access lists.
100 –199 – Extended IP access lists.
in – Specifies that filters will be applied to inbound packets.
out – Specifies that filters will be applied to outbound packets. If no direction (in or out) is
specified, the filter is applies to outbound packets by default.
specified, the filter is applies to outbound packets by default.
Table C-11. Filter Commands (4 of 4)