GoVideo dvp1100 제품 매뉴얼

To prevent fire, shock hazard, or annoying interference, use only the recom-

mended accessories.
To prevent electric shock, do not use this (polarized) plug with an extension cord, recep-

tacle, or other outlet unless the blades can be fully inserted to prevent blade exposure.
To reduce the risk of electric shock, do not remove the unit cover or back. There are no 

serviceable parts inside.
Refer servicing to qualified personnel only. 

TO AVOID HAZARDOUS EXPOSURE TO INVISIBLE LASER 

RADIATION, DO NOT OPEN OR REMOVE/DEFEAT LASER TRANSPORT PRO-

TECTIVE HOUSING.

This appliance is classified as a CLASS 1 LASER 

PRODUCT. The CLASS 1 LASER PRODUCT MARKING is located on the rear panel.

This reminder is provided to call the CATV sys-

tem installer’s attention to Article 820-40 of the National Electronic Code that provides 

guidelines for proper grounding and, in particular, specifies that the cable ground shall be 

connected to the grounding system of the building, as close to the point of cable entry as 

practical.

Your authority to operate this FCC certified equipment 

could be voided if you make changes or modifications not expressly approved by the 

manufacturer, who is responsible for compliance with Part 15 FCC rules. 
This equipment has been tested and found to comply with the limits for a Class B digital 

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide rea-

sonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate 

radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to 

radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equip-

ment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off 

and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and receiver.

•

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•

Consult the dealer or an experienced radio/TV technician for help.

Para prevenir incendio, riesgo de choque, o interferencia enfadosa, use solamente los accesorios recomendados. 

Para prevenir electrochoque, no use este enchufe (polarizado) con un cordón de extensión, toma de corriente, o cualquier otra 

toma a menos que los dientes puedan ser completamente insertados para prevenir exposición de los dientes. Para reducir el 

UG.book  Page 34  Thursday, January 9, 2003  10:05 AM