Printronix l7032 참조 매뉴얼

 118

The following commands illustrate solid lines in normal resolution. 
As shown in the examples, changing the horizontal and vertical 
line length parameter values constructs a variety of vertical and 
horizontal lines in varying line thicknesses.

With horizontal lines, the horizontal length parameter actually 
specifies line length and the vertical length parameter determines 
line thickness.

Similarly with vertical lines, the vertical length parameter specifies 
line length and the horizontal length parameter determines line 
thickness. (The Graphics Mode Enable command was previously 
sent to enable Graphics Mode but is not shown in the examples. 
Additionally, an alphanumerics command must be sent for line 
positioning but is not shown in the examples.)

^LS0425,0010^-

^LS0100,0100^-

^LS0001,0150^-

Provides eight pre-designed logos and symbols in different sizes 
and rotations totaling 14 new options. Logo Generation is used in 
conjunction with the Pixel Expansion command described on 
page 125

Graphics with an Extended Graphics Command selected

(cc) ILOGO, 

value (cc)G 

(cc)

Represents the Special Function Control Code 
(SFCC). Enter the specific SFCC for your VGL con-
figuration.

ILOGO,

The Logo Generation command. Enter ILOGO, (the 
comma following the command is required).

value

Represents the variable which selects the pre-
defined logo or symbol. Enter a 2-digit value from 
Table 14 representing the symbol or logo desired.

(cc)G

The required terminator for the ILOGO, command. 
Enter the SFCC for your VGL configuration fol-
lowed by a G to end the ILOGO, command 
sequence.