Printronix l7032 참조 매뉴얼
118
Chapter
2
Command Codes
Example
The following commands illustrate solid lines in normal resolution.
As shown in the examples, changing the horizontal and vertical
line length parameter values constructs a variety of vertical and
horizontal lines in varying line thicknesses.
As shown in the examples, changing the horizontal and vertical
line length parameter values constructs a variety of vertical and
horizontal lines in varying line thicknesses.
With horizontal lines, the horizontal length parameter actually
specifies line length and the vertical length parameter determines
line thickness.
specifies line length and the vertical length parameter determines
line thickness.
Similarly with vertical lines, the vertical length parameter specifies
line length and the horizontal length parameter determines line
thickness. (The Graphics Mode Enable command was previously
sent to enable Graphics Mode but is not shown in the examples.
Additionally, an alphanumerics command must be sent for line
positioning but is not shown in the examples.)
line length and the horizontal length parameter determines line
thickness. (The Graphics Mode Enable command was previously
sent to enable Graphics Mode but is not shown in the examples.
Additionally, an alphanumerics command must be sent for line
positioning but is not shown in the examples.)
^LS0425,0010^-
^LS0100,0100^-
^LS0001,0150^-
Logo Generation (Version II)
Purpose
Provides eight pre-designed logos and symbols in different sizes
and rotations totaling 14 new options. Logo Generation is used in
conjunction with the Pixel Expansion command described on
page 125
and rotations totaling 14 new options. Logo Generation is used in
conjunction with the Pixel Expansion command described on
page 125
Mode
Graphics with an Extended Graphics Command selected
Format
(cc) ILOGO,
value (cc)G
(cc)
Represents the Special Function Control Code
(SFCC). Enter the specific SFCC for your VGL con-
figuration.
(SFCC). Enter the specific SFCC for your VGL con-
figuration.
ILOGO,
The Logo Generation command. Enter ILOGO, (the
comma following the command is required).
comma following the command is required).
value
Represents the variable which selects the pre-
defined logo or symbol. Enter a 2-digit value from
Table 14 representing the symbol or logo desired.
defined logo or symbol. Enter a 2-digit value from
Table 14 representing the symbol or logo desired.
(cc)G
The required terminator for the ILOGO, command.
Enter the SFCC for your VGL configuration fol-
lowed by a G to end the ILOGO, command
sequence.
Enter the SFCC for your VGL configuration fol-
lowed by a G to end the ILOGO, command
sequence.