Netgear GSM712 사용자 설명서

6-12

Command Line Interface

<VLAN index #>

 = The VLAN ID. Adding the VLAN ID to the show vlan command displays 

the port that belongs to that particular VLAN. For example, show vlan 1 displays the ports that 
belong to VLAN 1. 

An example of the display output is shown below:.
Untagged port members: 4,5,7,11-15,19-23
Tagged port members: none

The 

show vlan cos-pvid

 displays the PVIDs and the CoS settings of each port. 

Syntax

An example of the display output is shown below:

Port     PVID   Priority
------------------------
1:1      1      Normal
1:2      1      Normal
1:3      1      Normal
1:4      1      Normal
1:5      1      Normal

Entering the command 

configure

 at the root prompt takes you into configuration mode. When 

you’re in configuration mode, the prompt changes to 

It is in this mode where the vast majority of configuration is performed. To exit the configuration 
mode and return to root prompt, use the exit command. 

DiffServ divides traffic into one of 64 classes using the packet’s DSCP value. This allows for 
greater differentiation of traffic priority than port-based traffic prioritization.

Syntax