Netgear fsm7352ps 작동 가이드
Page 12 of 24
4-10/100/1000M Ports
Three LED / Port
Copper Link/ACT LED :
•
OFF –No 10/100/1000Mbps link is established on the port.
•
Solid Green – A valid 1000Mbps link is established on the port.
•
Solid Yellow – A valid 10/100Mbps link is established on the port.
•
Blinking Green – Packets transmission or reception is occurring on the
port at 1000Mbps.
port at 1000Mbps.
•
Blinking Yellow – Packets transmission or reception is occurring on the
port at 10/100Mbps.
port at 10/100Mbps.
SFP Link/ACT LED :
•
OFF –No 1000Mbps link is established on the port.
•
Solid Green – A valid 1000Mbps link is established on the port.
•
Blinking Green – Packets transmission or reception is occurring on the
port at 1000Mbps.
port at 1000Mbps.
Stack LED:
In Stack mode
In Stack mode
•
Green –When stack partner successfully established the link.
•
Blinking Green –when switch detects the link active but stack partner
failed to establish the link
failed to establish the link
•
OFF –No link
In Non-stack mode
•
OFF –Regardless the link is present or not
Console Port
Your NETGEAR Model FSM7352PS ProSafe 48+4 Fast Ethernet L3 Managed Stackable Switch with PoE
has a console port on the front panel. This port is labeled Console and is required for initial
management configuration of the switch. It also lets you manage the switch using a directly connected
VT-100 terminal, personal computer (PC), Apple Macintosh, or UNIX workstation. The terminal, computer,
or workstation connects to the console port using the null-modem cable supplied with your switch.
has a console port on the front panel. This port is labeled Console and is required for initial
management configuration of the switch. It also lets you manage the switch using a directly connected
VT-100 terminal, personal computer (PC), Apple Macintosh, or UNIX workstation. The terminal, computer,
or workstation connects to the console port using the null-modem cable supplied with your switch.
The console port is configured to use the following settings:
•
Baud rate: 9,600 bps
•
Data bits: 8
•
Parity:
none
•
Stop bit: 1
•
Flow control: none
These settings appear below the connector on the switch front panel.
In addition to using the console port, you can manage the switch using a Web browser or a Simple Network
Management Protocol (SNMP) management program.
For more information about console-port connections, see “Connecting to the Console Port” in Chapter 3
Installation. For more information about managing the switch, see the User Manual located on the CD-
ROM.
In addition to using the console port, you can manage the switch using a Web browser or a Simple Network
Management Protocol (SNMP) management program.
For more information about console-port connections, see “Connecting to the Console Port” in Chapter 3
Installation. For more information about managing the switch, see the User Manual located on the CD-
ROM.