Netgear fsm7352ps 작동 가이드

Page 14 of 24 

 

You can install your NETGEAR Model FSM7352PS ProSafe 48+4 Fast Ethernet L3 Managed Stackable 
Switch with PoE on a flat surface or in a standard 19-inch rack. 
 
Installing the Switch on a Flat Surface 
The switch ships with four self-adhesive rubber footpads. Stick one rubber footpad on each of the four 
concave spaces on the bottom of the switch. The rubber footpads cushion the switch against 
shock/vibrations.  
 
Installing the Switch in a Rack 
To install the switch in a rack, use the following procedure (and refer to Figure 3-1). To perform this 
procedure, you need the 19-inch rack-mount kit supplied with your switch. 

1.  Attach the supplied mounting brackets to the side of the switch.  

2.  Insert the screws provided in the rack-mount kit through each bracket and into the bracket mounting 

holes in the switch.  

3.  Tighten the screws with a #1 Phillips screwdriver to secure each bracket.  

4.  Align the mounting holes in the brackets with the holes in the rack, and insert two pan-head screws with 

nylon washers through each bracket and into the rack.  

5.  Tighten the screws with a #2 Phillips screwdriver to secure the switch in the rack. 

 

 

Figure 3-1. Attaching Mounting Brackets  

 

Before you apply power: 
 

o

  Inspect the equipment thoroughly.  

o

  Verify that all cables are installed correctly.  

o

  Check cable routing to make sure cables are not damaged or create a safety hazard.  

o

  Be sure all equipment is mounted properly and securely. 

 

NETGEAR Model FSM7352PS ProSafe 48+4 Fast Ethernet L3 Managed Stackable Switch with PoE does