Netgear GSM7212 사용자 설명서
User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
Switching Commands
8-21
December 2004, 202-10010-02
no remotecon maxsessions
This command sets the maximum number of remote connection sessions that can be established to
the default value.
the default value.
Default
5
Format
no remotecon maxsessions
Mode
Privileged EXEC
remotecon timeout
This command sets the remote connection session timeout value, in minutes. A session is active as
long as the session has been idle for the value set. A value of 0 indicates that a session remains
active indefinitely. The time is a decimal value from 0 to 160.
long as the session has been idle for the value set. A value of 0 indicates that a session remains
active indefinitely. The time is a decimal value from 0 to 160.
Note:
Changing the timeout value for active sessions does not become effective until the session is
reaccessed. Any keystroke will also activate the new timeout duration.
Default
5
Format
remotecon timeout <0-160>
Mode
Privileged EXEC
no remotecon timeout
This command sets the remote connection session timeout value, in minutes, to the default.
Note:
Changing the timeout value for active sessions does not become effective until the session is
reaccessed. Any keystroke will also activate the new timeout duration.
Default 5
Format
no remotecon timeout
Mode
Privileged EXEC
serial baudrate
This command specifies the communication rate of the terminal interface. The supported rates are
1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200.
1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200.
Default
9600