Netgear FS116E 설치 설명서

)NSTALLATION

When you open the box, verify that you received everything. The package includes:

•

ProSafe 16-port 10/100Mbps Unmanaged Plus Switch FS116E

•

AC power adapter

•

Wall-mounting screws

•

Installation Guide (this document) 

•

Resource CD (contains switch configuration software)

If you do not have everything listed above, see the support information card for contact 
information. If you are missing the support information card, get contact information at 
http://www.NETGEAR.com in the Technical Support section.

Decide where you want to place the switch. Find a flat horizontal surface such as a table, 
desk or shelf. The switch comes with wall-mounting screws. You can use the screws if 
you want to hang the switch in an open space on a wall. Make sure the selected location is:

•

Not in direct sunlight or near a heater or heating vent.

•

Not cluttered or crowded. There should be at least 2 inches (5 cm) of clear space on 
all sides of the switch.

•

Well ventilated (especially if it is in a closet).

Also, you will need one Category 5e (Cat 5e) Ethernet cable with RJ-45 connectors for 
each device you want to connect to the switch. Each Ethernet cable must be less than 328 
feet (100 meters).

1. Place the switch on a flat surface or hook onto the screws.

2. For each device, insert one end of an Ethernet cable into the port in the device and 

insert the other end into one of the Ethernet ports on the switch.

3. Connect the power adapter cord into the back of the switch and then plug the adapter 

into a power source (such as a wall socket or power strip).

The Power light should light up.

4. Check the LEDs to confirm that all connections are correct.

Power

• On: 16-port Unmanaged Plus Switch has power.
• Off: No power.

RJ-45 ports

• Right LED on: 10 Mbps connection to a powered device.
• Left LED on: 100 Mbps connection to a powered device.
• Blink: Activity on this port. 

LOCAL
10/100M

Power

Reset

In order to make use of the switch’s enhanced features you can install and use a switch 
configuration utility. This utility is on the Resource CD shipped with the switch.
Note: The configuration utility is installed on your PC and is only supported on MS 
Windows.

To install the Unmanaged Plus Switch Configuration Utility:
1.  Insert the Resource CD into a PC connected to the switch.
2.  Click on Install NETGEAR UM+ Utility and follow the prompts to install the 

program. The switch configuration utility will be installed in the program directory of 
your PC and a NETGEAR UM+ Utility icon will be placed on your desktop.

To configure the switch to use enhanced features:
1.  Double click the NETGEAR UM+ Utility icon. The configuration home screen 

displays.

2.  The configuration utility displays a list of enhanced switches it discovers on the local 

network. Select the switch you want to configure.

3.  You will be asked to enter the password for the switch. The default is “password”.
4.  Enter the desired switch configuration. Refer to the Unmanaged Plus Switch 

Configuration Utility User Guide for a description of enhanced features. The user 
guide can be accessed by links on the Help tab of the utility or on the Resource CD.

FS116E_IG_12Aug09.fm  Page 1  Wednesday, August 12, 2009  10:13 AM