Netgear gsm7312 사용자 설명서
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Switching Commands
7-75
202-10009-01
Format
transfer upload mode <xmodem|tftp>
transfer upload serverip
This command sets the IP address of the server on which the file is located.
Note:
This command is valid only when the transfer mode is TFTP. See “transfer upload mode” .
Default
0.0.0.0
Format
transfer upload serverip <ipaddr>
transfer upload path
This command sets the directory path used to upload the file. The switch “remembers” the last file
path used.
path used.
Note:
This command is valid only when the transfer mode is TFTP. See “transfer upload mode” .
NETGEAR 7300 Series Layer 3 Managed Switch software supports the TFTP client. The TFTP
client path statement requirement is sever dependent. A path statement is generally required to set
up the TFTP client; however, the client path may remain blank.
client path statement requirement is sever dependent. A path statement is generally required to set
up the TFTP client; however, the client path may remain blank.
See the example of the path setup.
TFTP Upload Example:
The TFTP upload example details three scenarios for TFTP client to server file
transfer.
In the example, the operator will upload the config.bin file from the switch to
the location c:\tftp\ on the server. The different scenarios are detailed below:
transfer.
In the example, the operator will upload the config.bin file from the switch to
the location c:\tftp\ on the server. The different scenarios are detailed below:
NETGEAR 7300 Series Layer 3 Managed Switch software provides two methods to clear the
directory path statement.
directory path statement.
•
The
clear config
command will remove the directory path statement.
•
The web browser clear command will remove the directory path statement.
Default
Blank
Format
transfer upload path <path>
Table 3. TFTP Upload Example.
TFTP Server path
TFTP Client path
c:\tftp\
blank
c:\
tftp\
c:
\tftp\