Netgear gsm7312 사용자 설명서
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
9-16
Differentiated Services
202-10009-01
config diffserv policy class remove
This command deletes the instance of a particular class and its defined treatment from the
specified policy. The
specified policy. The
<policyname>
and
<classname>
are the names of an existing DiffServ
policy and class, respectively. Note that this command removes the reference to the class definition
for the specified policy.
for the specified policy.
Format
config diffserv policy class remove <policyname>
<classname>
config diffserv policy bandwidth kbps
This command identifies a minimum amount of bandwidth to be reserved for the specified class
instance within the named policy using an absolute rate notation. The
instance within the named policy using an absolute rate notation. The
<policyname>
and
<classname>
are the names of an existing DiffServ policy and class, respectively. The committed
information rate is specified in kilobits-per-second (Kbps) and is an integer from 1 to 4294967295.
Note: The actual bandwidth allocation does not occur until the policy is attached to an interface in
a particular direction.
a particular direction.
Note: The bandwidth kbps and percent commands are alternative ways to specify the same
bandwidth policy attribute.
bandwidth policy attribute.
Format
config diffserv policy bandwidth kbps <policyname>
<classname> <1-4294967295>
Restrictions
The sum of the committed information rate values for all bandwidth and
expedite commands defined within a policy must not exceed the available link
bandwidth of the interface to which that policy is assigned. Violation of this
requirement shall prevent successful attachment of a policy to the interface, or
shall cause this command to fail if the policy is already in service on one or
more interfaces.
expedite commands defined within a policy must not exceed the available link
bandwidth of the interface to which that policy is assigned. Violation of this
requirement shall prevent successful attachment of a policy to the interface, or
shall cause this command to fail if the policy is already in service on one or
more interfaces.
Policy Type
Out
Incompatibilities
Expedite (all forms)
config diffserv policy bandwidth percent
This command identifies a minimum amount of bandwidth to be reserved for the specified class
instance within the named policy using a relative rate notation. The
instance within the named policy using a relative rate notation. The
<policyname>
and
<classname>
are the names of an existing DiffServ policy and class, respectively. The committed
information rate is specified as a percentage of total link capacity and is an integer from 1 to 100.