Netgear gsm7312 사용자 설명서
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
9-18
Differentiated Services
202-10009-01
config diffserv policy expedite percent
This command identifies the maximum guaranteed amount of bandwidth to be reserved for the
specified class instance within the named policy using a relative rate notation. The
specified class instance within the named policy using a relative rate notation. The
<policyname>
and
<classname>
are the names of an existing DiffServ policy and class, respectively. The
committed information rate is specified as a percentage of total link capacity and is an integer from
1 to 100. The optional committed burst size is specified in kilobytes (KB) as an integer from 1 to
128, with a default of 4.
1 to 100. The optional committed burst size is specified in kilobytes (KB) as an integer from 1 to
128, with a default of 4.
Note: The actual bandwidth allocation does not occur until the policy is attached to an interface in
a particular direction.
a particular direction.
Note: The expedite kbps and percent commands are alternative ways to specify the same expedite
policy attribute.
policy attribute.
Format
config diffserv policy expedite percent <policyname>
<classname> <1-100> [1-128]
Restrictions
The sum of the committed information rate values for all bandwidth and
expedite commands defined within a policy must not exceed the available link
bandwidth of the interface to which that policy is assigned. Violation of this
requirement shall prevent successful attachment of a policy to the interface, or
shall cause this command to fail if the policy is already in service on one or
more interfaces.
expedite commands defined within a policy must not exceed the available link
bandwidth of the interface to which that policy is assigned. Violation of this
requirement shall prevent successful attachment of a policy to the interface, or
shall cause this command to fail if the policy is already in service on one or
more interfaces.
Policy Type
Out
Incompatibilities
Bandwidth (all forms), Shape Peak
config diffserv policy mark cos
This command marks all packets for the associated traffic stream with the specified class of
service value in the priority field of the 802.1p header. If the packet does not already contain this
header, one is inserted. The
service value in the priority field of the 802.1p header. If the packet does not already contain this
header, one is inserted. The
<policyname>
and
<classname>
are the names of an existing
DiffServ policy and class, respectively. The CoS value is an integer from 0 to 7.
Format
config diffserv policy mark cos <policyname>
<classname> <0-7>
Policy Type
Out