Netgear FVS338 참조 매뉴얼
Reference Manual for the ProSafe VPN Firewall 50 FVS338
8-8
Virtual Private Networking
January 2005
8.
Enter the LAN IP address and subnet mask of the remote FVX538.
Figure 8-10: LAN IP address and subnet mask of remote FVX538
9.
Click Next.
10.
Click Done to create the 'to_fvx' IKE and VPN policies.
Testing the Connection
1.
From a PC on either firewall's LAN, try to ping a PC on the other firewall's LAN. Establishing
the VPN connection may take several seconds.
the VPN connection may take several seconds.
2.
For additional status and troubleshooting information, view the VPN log and status menu in
the FVX538 or FVS338.
the FVX538 or FVS338.
Creating a VPN Connection: Netgear VPN Client to FVS338
This section describes how to configure a VPN connection between a Windows PC and the
FVS338 VPN firewall.
FVS338 VPN firewall.
Using the FVS338's VPN Wizard, we will create a single set of policies (IKE and VPN) that will
allow up to 50 remote PCs to connect from locations in which their IP addresses are unknown in
advance. The PCs may be directly connected to the Internet or may be behind NAT routers. If more
PCs are to be connected, an additional policy or policies must be created.
allow up to 50 remote PCs to connect from locations in which their IP addresses are unknown in
advance. The PCs may be directly connected to the Internet or may be behind NAT routers. If more
PCs are to be connected, an additional policy or policies must be created.
Each PC will use Netgear's VPN Client. Since the PC's IP address is assumed to be unknown, the
PC must always be the Initiator of the connection.
PC must always be the Initiator of the connection.