Netgear FVS338 참조 매뉴얼

4-4

Connecting the FVS338 to the Internet

This section provides instructions for connecting the FVS338 ProSafe VPN Firewall 50 to your 
Local Area Network (LAN).

The Resource CD included with your VPN firewall contains an animated Installation 

Assistant to help you through this procedure.

There are three steps to connecting your firewall:

•

Connect the VPN firewall to your network.

•

Log in to the VPN firewall.

•

Connect to the Internet.

Follow the steps below to connect your VPN firewall to your network.

a.

Turn off your computer and cable or DSL modem.

b.

Disconnect the Ethernet cable (A) from your computer which connects to your cable or 
DSL modem.

c.

Connect the Ethernet cable (A) from your cable or DSL modem to the FVS338’s Internet 
port.

d.

Connect the Ethernet cable (B) which came with the VPN firewall from a Local port on 
the router to your computer.

Note: The FVS338 VPN firewall incorporates Auto Uplink

TM

 technology. Each Ethernet 

port will automatically sense whether the cable plugged into the port should have a 
'normal' connection (e.g. connecting to a PC) or an 'uplink' connection (e.g. connecting to 
a switch or hub). That port will then configure itself to the correct configuration. This 
feature also eliminates the need to worry about crossover cables, as Auto Uplink will 
accommodate either type of cable to make the right connection.

e.

Turn on the cable or DSL modem and wait about 30 seconds for the lights to stop blinking.