Netgear FVS338 참조 가이드

2-1

This section provides instructions for connecting the VPN firewall. Setting up VPN tunnels are 
covered in 

1. Connect the firewall physically to your network. Connect the cables, turn on your router 

and wait for the Test LED to go out. Make sure your Ethernet and LAN LEDs are lit. (See the  
FVS338 ProSafe VPN Firewall 50 Installation Guide on your Resource CD.)

2. Log in to the firewall. After logging in, you are ready to set up and configure your firewall. 

You can also change your password and enable remote management at this time.

3. Configure the Internet connections to your ISPs. During this phase, you will connect to 

your ISPs. You can also program the WAN traffic meters at this time if desired.

4. Configure the WAN mode. Select either Primary Broadband with Dialup as backup or 

Use only single WAN port—and select the WAN port from the pull-down menu—either 
Broadband or Dial-up.

5. Configure dynamic DNS on the WAN ports (if needed). Configure your fully qualified 

domain names during this phase (if required).

6. Configure the WAN options (if needed). Optionally, you can enable each WAN port to 

respond to a ping. You can also change the factory default MTU size, port speed, and uplink 
bandwidth. However, these are advanced features and changing them is not usually required.

To physically connect your VPN firewall, refer to the IFVS338 ProSafe VPN Firewall 50 
Installation Guide (a copy is also available on your Resource CD).

Note: To connect to the firewall, your computer needs to be configured to obtain an IP 

address automatically via DHCP.