Adtran 4305 설치 설명서
NetVanta 4305 Hardware Installation Guide
Physical Description
61200890L1-34H
Copyright © 2006 ADTRAN, Inc.
23
Reviewing the Rear Panel Design
Figure 2 shows the NetVanta 4305 (AC) rear panel and Figure 3 shows the NetVanta 4305 (DC) rear panel.
The chassis are shown with the T1/FT1 + DSX-1 NIM installed.
The chassis are shown with the T1/FT1 + DSX-1 NIM installed.
Figure 2. NetVanta 4305 (AC) Rear Panel Layout
Figure 3. NetVanta 4305 (DC) Rear Panel Layout
Rear Panel Interfaces and LEDs
10/100BaseT Ethernet Interface and Activity LEDs
The Ethernet ports (
ETH 0/1, ETH 0/2
) are RJ-48C connectors with LEDs. The yellow activity LED
flashes when data traffic is being sent or received on the Ethernet port. The green link LED is on when
the router has a good connection to the LAN. See Table A-1 on page 49 for the Ethernet port pinouts.
The Ethernet port provides the following:
•
the router has a good connection to the LAN. See Table A-1 on page 49 for the Ethernet port pinouts.
The Ethernet port provides the following:
•
10BaseT or 100BaseT with a single connector
•
Auto-negotiation
•
CSMA/CD
•
IEEE 802.3 compatibility
CONSOLE Interface
The
CONSOLE
interface is an EIA-232 serial port (DCE) which provides for local management and
configuration (via a DB-9 female connector). Table A-2 on page 49 shows the
CONSOLE
port pinouts.
NET/DBU Option Slots
The
SLOT 1 NET/DBU
and
SLOT 2 NET/DBU
option slots support various NIM plug-in modules.
These option modules are described in the section Option Modules on page 24.
Power Supply
The NetVanta 4305 (AC) has a worldwide auto-ranging AC power supply with an IEC connector. The
appropriate three-prong cable is included in the shipment. A 4-position terminal block is included in
the shipment for connection of the NetVanta 4305 (DC) to a 24 or 48 VDC power source. Please refer
to Supplying Power to the Unit on page 44 for connection details.
appropriate three-prong cable is included in the shipment. A 4-position terminal block is included in
the shipment for connection of the NetVanta 4305 (DC) to a 24 or 48 VDC power source. Please refer
to Supplying Power to the Unit on page 44 for connection details.
Connection directly to an external modem requires a cross-over cable.
SLOT 1 NET/DBU
CONSOLE
SLOT 2 NET/DBU
SLOT 3 WIDE MODULE
WAN-T1
DSX-1
DBU
ETH 0/1
ETH 0/2
100 -250VAC
50/60Hz
WAN-T1
DSX-1
DBU
WAN-T1
DSX-1
DBU