Netgear DGN2200M 사용자 설명서

Basic Functioning

After you turn on power to the router, the following sequence of events should occur:

When power is first applied, verify that the Power LED is on.

After approximately 10 seconds, verify the following:

The LAN Ports LEDs are lit for any local ports that are connected.

The DSL LED is lit.

If the DSL link LED is lit, a link has been established to the connected device. If a LAN 
port is connected to a 100 Mbps device, verify that the port’s LED is green. If the port is 
10 Mbps, the LED is amber.

If any of these conditions does not occur, see the appropriate following section.

Welcome Screen Displays instead of Router Main Menu

This situation can occur if the CD Setup Wizard does not finish successfully; the unit stays in 
Wizard Mode. If the Welcome screen displays instead of the main menu when you try to go to 
the Internet or log in to the wireless modem router, you can bypass the wizard using one of 
the following methods:

Log in to the wireless modem router at http://routerlogin.com/basicsetting.htm.

Reset the wireless modem router to factory defaults to take the router out of Wizard Mode 

altogether.

Troubleshoot with the LEDs

After you turn on power to the wireless modem router, the following sequence of events 
should occur:

When power is first applied, verify that the Power LED 

 is on.

After approximately 10 seconds, verify that:

The Power LED is green.

The LAN Ports LEDs are lit for any local ports that are connected. If a LAN port is 

connected to a 100 Mbps device, verify that the port’s LED is green. If the port is 10 
Mbps, the LED is amber.

The DSL LED is lit, indicating that a link has been established to the connected 

device.

The WiFi LED is lit.