Netgear DGND3700 사용자 가이드
NETGEAR VPN Configuration
166
N600 Wireless Dual Band Gigabit ADSL2+ Modem Router DGND3700
The LAN addresses used in this example are as follows:
Table 26.
Device
LAN IP Address
LAN Subnet Mask
DGND3700
10.5.6.1
255.255.255.0
FVL328
172.23.6.1
255.255.255.0
a. For the connection name, enter toFVL328.
b. For the remote WAN's IP address, enter fvl328.dyndns.org.
c. Enter the following:
•
IP Address. 172.23.9.1
•
Subnet Mask. 255.255.255.0
5.
Configure the FVL328 as in the gateway-to-gateway procedures for the VPN Wizard (see
on page 101), being certain to use
appropriate network addresses for the environment.
a. For the connection name, enter toDGND3300v2.
b. For the remote WAN's IP address, enter dgnd3300v2.dyndns.org.
c. Enter the following:
•
IP Address. 10.5.6.1
•
Subnet Mask. 255.255.255.0
6.
Test the VPN tunnel by pinging the remote network from a PC attached to the N600
Wireless Dual Band Gigabit ADSL2+ Modem Router DGND3700.
Wireless Dual Band Gigabit ADSL2+ Modem Router DGND3700.
a. Open the command prompt (select Start > Run > cmd)
b. Type
ping 172.23.9.1
.
If the pings fail the first time, try the pings a second time.
Configuration Summary (Telecommuter Example)
The configuration in this section follows the addressing and configuration mechanics defined
by the VPN Consortium. Gather the necessary information before you begin configuration.
by the VPN Consortium. Gather the necessary information before you begin configuration.