Netgear DGND3700 사용자 가이드

Router Setup Preparation

You can set up your wireless modem router with the Setup Wizard as described in 

on page 27 or manually as described in 

However, before you start the setup process, you need to have your ISP information on hand 
and make sure the laptops, PCs, and other devices in the network have the settings 
described here.

If you have a Macintosh or Linux system, you have to use the 

manual setup method.

Use Standard TCP/IP Properties for DHCP

If you configured your computer to use a static IP address, you need to change the settings 
back so that it uses Dynamic Host Configuration Protocol (DHCP). See 

 for more information.

Replace an Existing Router

To replace an existing router, disconnect it completely from your network and set it aside 
before starting the router setup. 

Adapters and Security Settings

A wireless adapter is the wireless radio in your PC or laptop that lets the PC or laptop 
connect to a wireless network. Most PCs and laptops come with an adapter already installed, 
but if it is outdated or slow, you can purchase a USB adapter to plug into a USB port.

Make sure the wireless adapter in each computer in your wireless network supports the same 
security settings as the wireless modem router. See 

on page 37 for information about the router’s security settings.

If you connect devices to your modem router using WPS as 

described in 

on page 40, 

those devices assume the security settings of the router.

Gather ISP Information

You need the following information to set up your wireless modem router and to check that 
your Internet configuration is correct. Your Internet service provider (ISP) should have 
provided you with all of the information needed to connect to the Internet. If you cannot locate