Netgear DGND3700 사용자 가이드
Virtual Private Networking
90
N600 Wireless Dual Band Gigabit ADSL2+ Modem Router DGND3700
•
When the VPN Wizard and its VPNC defaults (see
on page 89) are not
appropriate for your special circumstances and you have to specify each phase of the
connection, see
connection, see
on page 119. You
manually enter all the authentication and key parameters. You have more control over the
process; however, the process is more complex, and there are more opportunities for
errors or configuration mismatches between your N600 Wireless Dual Band Gigabit
ADSL2+ Modem Router DGND3700 and the corresponding VPN endpoint gateway or
client workstation.
process; however, the process is more complex, and there are more opportunities for
errors or configuration mismatches between your N600 Wireless Dual Band Gigabit
ADSL2+ Modem Router DGND3700 and the corresponding VPN endpoint gateway or
client workstation.
Set Up a Client-to-Gateway VPN Configuration
Setting up a VPN between a remote PC running the NETGEAR ProSafe VPN client and a
network gateway involves two steps, described in the following sections:
network gateway involves two steps, described in the following sections:
on page 90 describes how to use
the VPN Wizard to configure the VPN tunnel between the remote PC and network
gateway.
gateway.
on page 93 shows how to configure
the NETGEAR ProSafe VPN client endpoint.
VPN tunnel
Internet
PC running NETGEAR
ProSafe VPN client
ProSafe VPN client
22.23.24.25
0.0.0.0
IP: 192.168.3.1
Figure 43. Wireless Modem Router DGND3700 client-to-gateway VPN tunnel
Step 1: Configure the Client-to-Gateway VPN Tunnel
This section describes using the VPN Wizard to set up the VPN tunnel using the VPNC
default parameters listed in
default parameters listed in
on page 89. If you have special requirements not
covered by these VPNC-recommended parameters, see
on page 111 for information about how to set up the VPN tunnel.