Quantum DLT-S4 사용자 가이드
Chapter 10 Installing an Internal Fibre Channel Tape Drive
Adding Additional Devices
DLT-S4 Product Manual
88
Adding Additional Devices
10
Once you have successfully confirmed the installation of your tape drive,
you may add additional devices.
For each additional device:
For each additional device:
1
Ensure that both the tape drive and computer are turned off.
2
Insert the fiber optic cable into the Fibre Channel port on the device
(for tape drives see
).
The connector is fully seated when it snaps into the port.
3
Insert the other end of the fiber optic cable into the Fibre Channel
port on the host computer.
4
Check all cable connections and ensure that they are attached
correctly and seated firmly before turning the system on.
5
Confirm the installation (see
Using the Loader/Library Interface Connector
10
This connector is only used for tape drives installed in loaders/libraries.
If your system requires it to be used, it should have been pre-assembled
If your system requires it to be used, it should have been pre-assembled
at the factory. For more information about the loader/library connector,
see