Quantum DLT-S4 Betriebsanweisung

Chapter 10  Installing an Internal Fibre Channel Tape Drive

Adding Additional Devices

DLT-S4 Product Manual

88

Adding Additional Devices

10

Once you have successfully confirmed the installation of your tape drive, 

you may add additional devices. 
For each additional device:

Ensure that both the tape drive and computer are turned off.

Insert the fiber optic cable into the Fibre Channel port on the device 

(for tape drives see 

). 

The connector is fully seated when it snaps into the port.

Insert the other end of the fiber optic cable into the Fibre Channel 

port on the host computer.

Check all cable connections and ensure that they are attached 

correctly and seated firmly before turning the system on. 

Confirm the installation (see 

Using the Loader/Library Interface Connector

10

This connector is only used for tape drives installed in loaders/libraries. 
If your system requires it to be used, it should have been pre-assembled 

at the factory. For more information about the loader/library connector, 

see