AASTRA cm16 설치 설명서

www.aastra.com 

 

 

The Base Station Unit will not operate unless connected to a “working” M1 digital line card and the Handset battery will 
not charge unless the Base Station is properly connected. 

 

•  The Base Station Unit must be connected to a digital M1 line card and configured as per the M20xx, M2616 or 

M39xx (M39xx feature function keys will not be represent on the CM-16, however the permanent program keys will 
be available).  

•  Once you have configured the digital line, you can test the digital line/jack using a M2616 or M2008 or other.  
•  The polarity of the M1 digital line circuit must be correct as shown in Fig. 1. 
•  The CM16 can be added as an extension using the second port of an existing line card. 

There are seven steps required in the installation process. Please follow the steps in sequential order. 

 

Refer to Figure 1 and connect the components in this order.  

 

1)  Plug one end of the 6 conductor cord (supplied) to the Base Station Unit, connection         on Fig.1  

 

2)  Plug the other end of the 6 conductor cord into the jack on the Power Adapter Assembly, connection        on Fig.1 

 

3)  Plug the Power Adapter Assembly into a known working AC outlet, connection         on Fig. 1 

 

If the power connections are good the Base Station Unit Left LED will be very dimly lit, and the center and right LEDs 
will be off.  
You may have to shield ambient light from the left LED with your hand to see that the LED is on.  
If this LED it is not on, there is either a problem with the power connections or line cords or the AC outlet is not 
working. Correct the problem before continuing. 

 

4)  Place the battery in the compartment and slide the door closed as shown in Fig. 2 
The handset should display CM-16 briefly and then go to idle screen with date and time displayed.  
The date and time will change to the M1 system values after step 7. 

1

2

3