AASTRA cm16 설치 설명서
www.aastra.com
4
5) Plug the modular cord of the “cradle power adapter” into the jack on the bottom of the cradle. Route the cord
through the retaining tabs of the molded cord slot. Verify the cradle rests properly and doesn’t wobble.
6) Plug the charging cradle transformer into a known working non-switched AC outlet as shown in Fig. 3.
7) Refer to Fig. 1 - Connect the short line cord tail of the power adapter assembly to the M1 wall jack. The CM-16
should power up with this connection, so check for the following Base Station Unit and Handset ICON indications.
Base Station Unit LEDS
If all connections are correct to this point, the right LED will start blinking (and continue blinking for about 40 seconds
as the Base Station Unit scans for its Handset). This blinking right LED also indicates the radio circuit is fully powered.
The left LED will now be on steady indicating power from the M1 digital line card is present. The center LED will blink
twice per second indicating that the M1 is communicating with the CM-16. If you do not see all of these indicators,
repeat steps 1,2,3 and 7 to find the problem.
as the Base Station Unit scans for its Handset). This blinking right LED also indicates the radio circuit is fully powered.
The left LED will now be on steady indicating power from the M1 digital line card is present. The center LED will blink
twice per second indicating that the M1 is communicating with the CM-16. If you do not see all of these indicators,
repeat steps 1,2,3 and 7 to find the problem.
Handset ICON
Check for the Antenna ICON to display in the handset – just to the right of the battery icon.
Place a test call…
From another M1 station, call this DN and answer the call by pressing the Handset Key (to the left of the “M”
key). Verify the transmission and hang up by pressing the key to the right of the “M” key.
From another M1 station, call this DN and answer the call by pressing the Handset Key (to the left of the “M”
key). Verify the transmission and hang up by pressing the key to the right of the “M” key.
8) Important: Use the handset until the battery is fully discharged and then place the handset in the charging cradle.
• There is no power light on the cradle. You must check the handset battery icon.
NOTE:
When the handset is placed in the cradle the first time, or if the battery was fully discharged, or if you unplug and
reconnect a battery, the battery icon will blink with four bars from left to right to indicate that the battery is being
charged.
After 4 hours the 4 bars will be on steady indicating a full charge condition.
When the handset is placed in the cradle the first time, or if the battery was fully discharged, or if you unplug and
reconnect a battery, the battery icon will blink with four bars from left to right to indicate that the battery is being
charged.
After 4 hours the 4 bars will be on steady indicating a full charge condition.