Uniden udw10003 사용자 설명서
19
Signal Level
Icon
Data Rate (kbps)
Frames per second (approx)
QVGA (Zoom)
VGA (Normal)
Perfect
1062~1280
15~20
5~10
Good
725~1062
12~16
3~5
Fair
543~725
8~12
2~4
Low
250~543
0~5
0~1
Zero
0~250
0
0
If the suggestions above don’t provide enough improvement in the the signal quality, you may
want to run the camera at QVGA or zoom mode. When the camera is in zoom mode, it sends fewer
pixels to the receiver, so the video performance is not as affected by the weak signal.
want to run the camera at QVGA or zoom mode. When the camera is in zoom mode, it sends fewer
pixels to the receiver, so the video performance is not as affected by the weak signal.
Noise or Static
The most likely cause of noise (flickering image) or static is interference. There are many common
sources of interference:
sources of interference:
electrical appliances, especially microwave ovens
computer equipment, especially wireless LAN equipment
other radio-based wireless devices, such as cordless telephones
wireless controllers, or wireless headphones or speakers
large florescent light fixtures (especially if they give off a buzzing noise)
working motors (hair dryers, heater/air conditioners, water pumps)
computer equipment, especially wireless LAN equipment
other radio-based wireless devices, such as cordless telephones
wireless controllers, or wireless headphones or speakers
large florescent light fixtures (especially if they give off a buzzing noise)
working motors (hair dryers, heater/air conditioners, water pumps)
►
►
►
►
►
►