ZyXEL p-330w 빠른 설정 가이드
ZyXEL P-330W
2 Hardware Installation
2.1 Rear Panel
LABEL DESCRIPTION
POWER
Connect the end of the included power adaptor (use only this adapter) to this power socket.
LAN 1-4
Use an Ethernet cable to connect at least one computer for initial P-330W configuration. These
ports are auto-negotiating (can connect at 10 or 100Mbps) and auto-sensing (automatically
adjust to the type of Ethernet cable you use (straight-through or crossover)).
ports are auto-negotiating (can connect at 10 or 100Mbps) and auto-sensing (automatically
adjust to the type of Ethernet cable you use (straight-through or crossover)).
WAN
Connect your cable/satellite/DSL modem to this port with the cable that came with your modem.
RESET
You only need to use this button if you’ve forgotten the P-330W’s password. Push the button for
less than 5 seconds to cause the P-330W to reboot, push for 10 seconds to cause the P-330W to
reset to factor defaults. See your User’s Guide for details).
less than 5 seconds to cause the P-330W to reboot, push for 10 seconds to cause the P-330W to
reset to factor defaults. See your User’s Guide for details).
Antenna
The P-330W uses a RP-SMA connection to attach the antenna for wireless networking. The
antenna will need to be attached here before you can use the wireless LAN.
antenna will need to be attached here before you can use the wireless LAN.
After you’ve made the connections, connect the power cable to a power supply and look at the front panel LEDs.
3