ZyXEL P-2602HW 사용자 설명서

Chapter 13 Phone Usage

P-2602H(W)(L)-DxA User’s Guide

Do the following to listen to the ZyXEL Device’s current IP address. 

1 Pick up your phone’s receiver.
2 Press “****” on your phone’s keypad and wait for the message that says you are in the  

configuration menu. 

3 Press “5” followed by the # key.
4 Listen to the IP address and make a note of it.
5 Hang up the receiver.

If your service provider uses an auto-provisioning server to set up your device, you must first 
enter the HTTP pincode (supplied by your service provider). This authenticates your ZyXEL 
Device with the auto provisioning server, allowing you to use the service.

• On a phone connected to the device, enter “*99**”, your SIP number, “*”, the HTTP 

pincode you were given, then “#”.

• For example, if your SIP number is 0123456 and the HTTP pincode you were given is 

9876, you would enter “*99**0123456*9876#”.

During auto-provisioning, the ZyXEL Device checks to see if there is a newer firmware 
version (if your service provider activates this feature). If newer firmware is available, the 
ZyXEL Device plays a recording when you pick up your phone’s handset.

• Press “*99#” to upgrade the ZyXEL Device’s firmware.
• Press “#99#” to not upgrade the ZyXEL Device’s firmware.

The following table shows the key combinations you can enter on your phone’s keypad to use 
certain features. 

Table 73   Phone Functions Summary

****

IVR

Use this to set up Interactive Voice Response. IVR allows 

you to record custom caller ringing tones (the sound a 

caller hears before you pick up the phone) and on hold 

tones (the sound someone hears when you put their call 

on hold). See 

#### 

Internal call

Call the phone(s) attached to the ZyXEL Device’s other 

.

*99** 

HTTP pincode

Use this if your service provider gave you a personal 

identification number to enter in order to start using the 

service. See 

*99# 

Enable firmware update

Use these to upload or not upload new firmware to the 

ZyXEL Device, if requested by your service provider. See 

.

#99#

Disable firmware update