ZyXEL 793H 사용자 가이드

P-793H User’s Guide

Use this menu to configure the DSL connection, traffic redirect, and dial-backup interface.

From the main menu, enter 2 to open menu 2.

Figure 142   Menu 2: WAN Setup

The following table describes the fields in this screen.

                               Menu 2 - WAN Setup

          Service Mode= 2wire
          Service Type= Server
            Rate Adaption= Disable                Rate Adaption= N/A
            Transfer Max Rate(Kbps)= 5696         Transfer Max Rate(Kbps)= N/A
            Transfer Min Rate(Kbps)= 192         Transfer Min Rate(Kbps)= N/A
            Standard Mode= ETSI(ANNEX_B)          Standard Mode= N/A
          Wan Backup Setup:
            Check Mechanism = ICMP
            Check WAN IP Address1 = 0.0.0.0
            Check WAN IP Address2 = 0.0.0.0
            Check WAN IP Address3 = 0.0.0.0
              KeepAlive Fail Tolerance = 31
              Recovery Interval(sec) = 3
              ICMP Timeout(sec) = 9677
            Traffic Redirect = No
            Dial Backup = No

Table 94   Menu 2: WAN Setup

Service Mode

Press [SPACE BAR] to indicate whether the ZyXEL Device should use 2-wire or 4-

wire mode for the DSL connection. This is related to the phone line you use and 

affects the maximum speed of the connection. In 2-wire mode, the maximum data 

rate is up to 5.69 Mbps, while in 4-wire mode, the maximum data rate us up to 11.38 

Mbps. See 

 for information on 2wire-2line service mode.

Service Type

Press [SPACE BAR] to indicate whether the ZyXEL Device is the server or the client 

in the DSL connection. Select Server if this ZyXEL Device is the server in a point-to-

point application. (See 

.) Otherwise, select Client.

Rate Adaption

This field is configurable if Service Type is Server. Press [SPACE BAR] to let the 

ZyXEL Device adjust the speed of its connection to that of the other device.