ZyXEL 793H 사용자 가이드

Chapter 26 Remote Node Setup

P-793H User’s Guide

Figure 154   Menu 11.1: Remote Node Profile (nodes 1-7)

The following table describes the labels in this menu.

                         Menu 11.1 - Remote Node Profile

     Rem Node Name= MyISP                 Route= IP
     Active= Yes                          Bridge= No

     Encapsulation= PPPoE                 Edit IP/Bridge= No
     Multiplexing= LLC-based              Edit ATM Options= No
     Service Name=                        Edit Advance Options= No
     Incoming:                            Telco Option:
       Rem Login=                           Allocated Budget(min)= 0
       Rem Password= ********               Period(hr)= 0
     Outgoing:                              Schedule Sets=
       My Login=                            Nailed-Up Connection= No
       My Password= ********              Session Options:
       Authen= CHAP/PAP                     Edit Filter Sets= No
     Line=1                                 Idle Timeout(sec)= 0

Table 102   Menu 11.1: Remote Node Profile (nodes 1-7)

Rem Node Name

Enter the name of the ISP.

Active

Select whether or not you want to use this Internet connection.

Encapsulation

Select the type of encapsulation your ISP uses.

Multiplexing

Select the method of multiplexing used by your ISP from the drop-down list. 

Choices are VC or LLC.

Service Name

(PPPoE only) Enter the service name provided by your ISP. Leave this field 

blank if your ISP did not provide one.

Incoming

This section is only enabled for PPPoA or PPPoE connections.

Rem Login

Type the login name that this remote node will use to call your ZyXEL Device. 

The login name and the Rem Password will be used to authenticate this node.

Rem Password

Type the password used when this remote node calls your ZyXEL Device.

Outgoing

This section is only enabled for PPPoA or PPPoE connections.

My Login

Enter the user name provided by your ISP.

My Password

Enter the password provided by your ISP.

Retype to Confirm

Enter the password again.

Authen

This field appears if you select PPPoE in the Encapsulation field. Select what 

type of authentication your ISP uses. Select CHAP/PAP if you want the ZyXEL 

Device to support both choices.

Line

Select the DSL connection you want the ZyXEL Device to use for outgoing 

traffic. 

Route

Press [SPACE BAR] and then [ENTER] to select IP to enable IP-based routing 

to this remote node. This is not effective unless you enable IP-based routing in 

the ZyXEL Device too. See 

You should enable Route IP, Bridge, or both in this screen. If you disable 

Route IP and Bridge, the device does not send traffic between the LAN ports 

and remote node.