ZyXEL 793H 사용자 가이드

 Chapter 4 Point-to-(2)point Configuration

P-793H User’s Guide

3 Set the VPI, VCI, Multiplexing, and Encapsulation to the same values you set in the 

server.

4 Scroll down to the Service Type section. See 

 above.

5 In the Service Mode field, select the same type of connection you selected for the server.
6 In the Service Type field, select Client. The rest of the fields will be negotiated with the 

server.

7 Click Apply.

Connect the DSL ports on the ZyXEL Devices together, and wait while the ZyXEL Devices 
automatically establish the connection. When the connection is established, the DSL1, DSL2, 
and INTERNET lights are on. It takes up to half a minute to establish the connection. If the 
ZyXEL Devices do not establish the connection, verify that the settings (except the Service 
Type) match.

You can set up a point-to-2points connection between a server ZyXEL Device and two client 
ZyXEL Devices. This configuration offers a secure and cost-effective way to create a private 
IP network. An example is shown below.

Figure 23   Example: Point-to-2points Connection

In a point-to-2points connection, the DSL port on the server ZyXEL Device (A) uses a Y-
cable to create two DSL connections. The connections can use RFC 1483 in bridge mode or 
ENET ENCAP in router mode. You can set up one set of transfer rate settings and modes 
between the server ZyXEL Device A and the client ZyXEL Device B. You can set up a 
different set of settings between the server ZyXEL Device A and the client ZyXEL Device C.