IQinVision iq510 참조 가이드
Page 14 of 60
3.5.7. Image control
Name
OID Value
Description
Gamma
1.2.1
Image gamma setting. Default value depends on the camera model.
Downsample
1.2.2
Specifies the factor that will be used to reduce the size of an image
when a default image is requested. Values are powers of two, i.e. 1,
2, 4, 8.
when a default image is requested. Values are powers of two, i.e. 1,
2, 4, 8.
Sharpness
1.2.3
Sharpening to be applied to images. Default depends on the camera
model.
model.
Image flip
1.2.4
Specifies how the image should be manipulated. Permissible values
depend on the camera model. Default is no flip.
depend on the camera model. Default is no flip.
JPEG Quality
1.2.7
Specifies how much compression should be applied when creating
JPEG images. Higher values have higher quality, i.e. the least
compression. Different camera models have different ranges so see
the individual camera documentation for the specific range.
JPEG images. Higher values have higher quality, i.e. the least
compression. Different camera models have different ranges so see
the individual camera documentation for the specific range.
Lighting Frequency 1.2.12.1
Lighting frequency to be used to compensate for fluorescent lighting
beating. Valid values are 50 or 60. Default is 60.
beating. Valid values are 50 or 60. Default is 60.
Saturation
1.2.21
Color saturation target. Specifying higher saturation values will
result in move vivid colors. Default value depends on the camera
model.
result in move vivid colors. Default value depends on the camera
model.
Lightgrabber
1.2.30
Lightgrabber setting. Permissible values are 0, 1, 2, 4. Default
value depends on the camera model.
value depends on the camera model.
Maximum frame
rate
rate
1.2.31
Maximum frame rate the camera will be allowed to deliver. Default
is half of the maximum frame rate for each camera model.
is half of the maximum frame rate for each camera model.
Reset image
parameters to
factory defaults
parameters to
factory defaults
1.2.14
Writing this write only OID with the value “1” will reset all image
parameters back to their factory default values.
parameters back to their factory default values.