MicroBoards pf3-1000 사용자 가이드
MICROBOARDS TECHNOLOGY, LLC PF-3 PRINT FACTORY
9
Replacing Empty Ink Cartridges
The PF-3 Print Factory will notify you when either cartridge is completely empty. Since the current
print job will be cancelled at that point, it is strongly recommended that you replace the cartridges
when you are notified that they are low rather than waiting until they are empty.
print job will be cancelled at that point, it is strongly recommended that you replace the cartridges
when you are notified that they are low rather than waiting until they are empty.
Since the PF-3 Print Factory is designed for unattended operation, however, this may not always be
possible. If you see the Out of Ink message on your PC, please perform these steps:
possible. If you see the Out of Ink message on your PC, please perform these steps:
1. Open the front door of the PF-3 Print Factory.
2. When the carriage moves to center, remove the ink cartridge specified in the message.
3. Replace the cartridge and close the front door.
4. Press the Cancel button on the front printer control panel.
5. Wait for the printer to prime the cartridge. The priming cycle will
take approximately 70-80 seconds to complete. Do not perform the
next step until the priming cycle completes.
next step until the priming cycle completes.
6. After the disc ejects, click the OK button on the Out of Ink message.
Any time you change ink cartridges, you should always wait until the printer has primed the
cartridges before sending it a print job. The priming cycle will take 70-80 seconds to complete
after the door is closed.
cartridges before sending it a print job. The priming cycle will take 70-80 seconds to complete
after the door is closed.