Pyle plcd87 사용자 매뉴얼

4

1. Before removing the frame, press the

OPEN button to slide down the front 
panel.

2. Frame
3. Insert fingers into the groove in the 

right side of the frame and pull out to
remove the frame.  (You can also 
remove the frame from the left side.)

4. Lever

After removing the frame, press the 
OPEN button again to slide up the 
front panel.  Then insert the levers 
supplied with the unit into the grooves
at both sides of the unit as shown in 
figure until they click.  Pulling the 
levers makes it possible to remove the
unit from the dashboard.

Installation using the screw holes on the
sides of the unit.

Fastening the unit to the factory radio
mounting bracket.

1. Select a position where the screw 

holes of the bracket and the screw 
holes of the main unit become aligned
(are fitted), and tighten the screws at 
2 places on each side.
Use either truss screws (5 x 5mm), 
depending on the shape of the screw
holes in the bracket.

2. Screw
3.  Factory radio mounting bracket
4. Dashboard or Console

Note:  The mounting box, outer trim ring,
and half-sleeve are not used for method
B installation.

3

4

2

2

1

Open

1

2

3

4