JVC GR-D770 지침 매뉴얼

MasterPage: Left

During recording, a time code is recorded on 
the tape. This code is to confirm the location of 
the recorded scene on the tape during 
playback. 

* Frames are not displayed during recording.

If recording starts from a blank portion, the 
time code begins counting from “00:00:00” 
(minute:second:frame). If recording starts from 
the end of a previously recorded scene, the 
time code continues from the last time code 
number. If during recording a blank portion is 
left partway through the tape, the time code is 
interrupted. When recording is resumed, the 
time code starts counting up again from 
“00:00:00”. This means the camcorder may 
record the same time codes as those existing 
in a previously recorded scene. To prevent this, 
perform Recording From The Middle Of A Tape 
(

 pg. 20) in the following cases;

●

When shooting again after playing back a 
recorded tape.

●

When power shuts off during shooting. 

●

When a tape is removed and re-inserted during 
shooting.

●

When shooting using a partially recorded tape. 

●

When shooting on a blank portion located 
partway through the tape.

●

When shooting again after shooting a scene 
then opening/closing the cassette holder cover.

●

The time code cannot be reset.

●

During fast-forwarding and rewinding, the time 
code indication does not move smoothly.

●

The time code is displayed only when “TIME 
CODE” is set to “ON”. (

1) Play back a tape or use Blank Search 
(

 pg. 22) to find the spot at which you want 

to start recording, then engage the Still 
Playback mode. (

2) Set the Power Switch to “REC” while 
pressing down the Lock Button located on the 
switch, then start recording.

You can capture still images without disturbing 
the recording in progress. Press SNAPSHOT. 
A sub screen will be displayed for approx. 6 
seconds to show you the snapshot image. 

●

The Still image is saved into the memory card 
while video is recorded onto the cassette tape. 

●

“REC SELECT” must be set to “

 (CARD)” 

only. 

Press AUTO button repeatedly to switch to 
auto/manual recording mode.  When manual 
mode is selected, the indicator “

M” appears 

on the LCD monitor.

A

You can record using no special effects or 
manual adjustments.

M

Manual recording is possible by setting various 
functions

.

GR-D770UC_EN.book  Page 20  Thursday, December 14, 2006  7:55 PM