Haier cz51115 사용자 가이드

Page 7

Temperature in freezer is not cold

No power

Check fuse in plug and

enough

mains supply

Lid or drawer are open for too long

Do not open lid/drawer
needlessly

Temperature control set too low

Turn control towards 6

Abnormal noise and vibration

Freezer not level

Adjust feet to level the unit

Cabinet touching adjacent

Maintain gap between

wall

cabinet and wall

This product is supplied with a fitted plug which
contains a 13A fuse. If you are simply replacing the
fuse, you must use a 13A fuse which has been
approved by ASTA to BS1362.

If the plug does not fit the socket or becomes
damaged, a new plug must be fitted. Replace the
original plug with the correct plug for your socket. If
this is a 3-pin (square pin) 13A (BS1363) plug, you
must make sure that it is fitted with an ASTA
approved 13A fuse.

If another type of plug is used, it must be protected
by a 15A fuse, either in the plug or at the
distribution board.

1. Cut off the existing fitted plug.

2. The wires in the mains lead supplied with this
appliance are coloured in accordance with the
following code (Figure 5):

GREEN/YELLOW = EARTH (E)     
BLUE = NEUTRAL (N)        BROWN = LIVE (L)

This product must be earthed.

As the colours of the wires in the mains lead may
not correspond with the colour markings identifying
the terminals in your new plug, proceed as follows.

The wire which is coloured YELLOW/GREEN or
GREEN must be connected to the terminal which is
marked with the letter E or 

E symbol or coloured

YELLOW/GREEN or GREEN.

The wire which is coloured BLUE must be
connected to the terminal in the plug which is
marked with the letter N or coloured BLUE or
BLACK.

The wire which is coloured BROWN must be
connected to the terminal which is marked with the
letter L or coloured BROWN or RED.

3. Ensure that the connections are tight and that
no loose strands are left out of the terminals.

FUSE

26343-17 1 7.qxp   1/ 3/2

7  15: 8  Page 7