Rimage prism 사용자 가이드
Rimage PrismPlus!
14
110635_I
4. Prepare
the
Prism for use.
a. Power off the Prism.
b. Reinstall
the
ribbon.
c. Replace
the
top cover.
Note: If the printing pad on the tray becomes wet, allow the printing pad to completely dry
before using the Prism.
before using the Prism.
d. Power on the Prism.
Clean the print head – alternate method
If a cleaning pad is not available, use the following cleaning procedure.
1. Prepare
the
Prism.
a. Power on the Prism.
b. To open the printer tray, press the operator button.
c. Power down the Prism.
d. Remove
the
top cover.
e. Remove
the
ribbon. Refer to Changing the print ribbon on page 14.
2. Clean
the
print head.
-
Important! Do not remove the print head.
a. Lightly soak a cotton swab in isopropyl alcohol.
b. Insert
the
cotton swab in the drawer opening and lift the swab upward as you run the swab against
the print head elements.
3.
int head dries, prepare the Prism for use.
After the alcohol on the pr
a. Replace
the
ribbon.
r.
b. Replace
the
top cove
c.
Power on the Prism.
Changing the Print Ribbon
climated to the new environment. Allow more time for greater temperature and/or humidity
s at -5
°C (23°F) to 40°C (104°F) and at 30-80% relative humidity, non-condensing. Avoid
direct sunlight.
print head is still installed
Clean convex surface while
Bottom of print head shown
to illustrate elements to clean
to illustrate elements to clean
Tip: If ribbons are stored in an environment much different from that of the printer, allow time for them
to become ac
differences.
to become ac
differences.
Store the ribbon