PROSCAN psvr71 사용자 가이드
38
Program the Remote
About Programming the
Remote
Remote
The universal remote’s TV and SAT•CABLE buttons can be
programmed to control other brands of remote controlled TVs,
digital satellite receivers, and cable boxes. Your remote is already
programmed to operate most ProScan, RCA, and GE televisions as well
as digital satellite receivers.
programmed to control other brands of remote controlled TVs,
digital satellite receivers, and cable boxes. Your remote is already
programmed to operate most ProScan, RCA, and GE televisions as well
as digital satellite receivers.
The AUX button can be programmed to control a ProScan or RCA
auxiliary component.
auxiliary component.
Testing the Remote
To determine whether the universal remote needs to be programmed,
turn the component on (such as a TV), point the remote at the TV and
press the TV button. Then press ON•OFF, CH +, or CH - to see if the
TV responds to the remote commands. If the TV does not respond,
then the remote control needs to be programmed.
turn the component on (such as a TV), point the remote at the TV and
press the TV button. Then press ON•OFF, CH +, or CH - to see if the
TV responds to the remote commands. If the TV does not respond,
then the remote control needs to be programmed.
Programming the Remote to
Control a TV, Satellite Receiver,
or Cable Box
Control a TV, Satellite Receiver,
or Cable Box
The remote features Code Search, a technology that largely automates
the programming process. Follow these steps to program the remote to
control a TV, digital satellite receiver, or cable box.
the programming process. Follow these steps to program the remote to
control a TV, digital satellite receiver, or cable box.
1. Turn on the component you want to control (TV, digital satellite
receiver, or cable box).
2. Press and hold the button you want to program (TV or
SAT•CABLE). While holding the component button, press and
hold ON•OFF until the LED on the remote flashes, then release
both buttons.
hold ON•OFF until the LED on the remote flashes, then release
both buttons.
3. Press and release PLAY, then wait five seconds.
The remote searches through a set of codes. If, after five seconds,
the component does not turn off, press PLAY again to tell the
remote to search the next set of codes.
the component does not turn off, press PLAY again to tell the
remote to search the next set of codes.
You can press FORWARD to individually search through the last
ten codes that were transmitted when you pressed PLAY.
ten codes that were transmitted when you pressed PLAY.
You’ll use these buttons when you
program the remote to control a TV,
digital satellite receiver, or cable box.
TV
ON•OFF
SAT•CABLE
CH
+
CH
-
STOP
PLAY
REVERSE
CLEAR
FORWARD
LED