SATO CG412 사용자 가이드
Section 3: Operation and Configuration
Page 3-10
CG4 Series Operator Manual
3.4 FACTORY TEST PRINT MODE (cont’d)
Second print-out (Settings)
Third print-out (Interface)
This interface information is similar to the third print-out in user test print mode. Refer to Section 3.3.1 Output
Data of the User Test Print for details.
This interface information is similar to the third print-out in user test print mode. Refer to Section 3.3.1 Output
Data of the User Test Print for details.
No.
Print Item
Contents of the print data
1
Model
Printer model name
CG408TT(*), CG412TT(*)
CG408DT, CG412DT
*: “T” is printed for thermal
CG408DT, CG412DT
*: “T” is printed for thermal
transfer print.
“D” is printed for direct
thermal print.
2
Offset
Base reference correction
(Vertical and horizontal
directions)
(Vertical and horizontal
directions)
(H)±300 (V)±300 DOT
3
Pitch Offset
Pitch offset value
±099 DOT
4
Cut Offset
Cut position correction value
±099 DOT
5
Peel Offset
Peel off position correction
value
value
±099 DOT
6
Tear Off Offset
Tear off position correction
value
value
±099 DOT
7
Label Size
Label size (Pitch/Width)
(P)**** x (W)*** DOT
8
Print Speed
Print speed
50mm/s, 75mm/s, 100mm/s
9
Print Darkness
Print darkness
1A~5A
10
Sensor Type
Sensor type
Gap / I-Mark / None
11
Sensor Level Low
Average minimum value of
pitch sensor
pitch sensor
*.* V
12
Sensor Level High
Average maximum value of
pitch sensor
pitch sensor
*.* V
13
Sensor Slice Level
Pitch sensor slice level
*.* V
14
Paper End Search
Paper end detection method
TAG/ ROLL
15
Zero Slash
Zero slash
ON/ OFF
16
Proportional Pitch
Proportional pitch
ON/ OFF
17
Buzzer
Buzzer
ON/OFF
18
Initial Feed
Initial feed
ON/ OFF
19
Operation mode
Operation mode
CUT/ NONE SEPA/
TEAR OFF/ DISPENSER/
CONTINUOUS
TEAR OFF/ DISPENSER/
CONTINUOUS
20
Option waiting time
Option waiting time
500 to 20000 ms
21
Protocol-codes
Protocol code setting value
(Standard / Nonstandard)
(Standard / Nonstandard)
Nonstandard/ Standard