SATO CG412 사용자 가이드
Section 3: Operation and Configuration
Page 3-12
CG4 Series Operator Manual
3.5
OPERATION SETTING MODE
(cont’d)
Program Download
Mode
Mode
Font Download Mode
Default setting Mode
HEX Dump Mode
USB interface
RS-232C/ LAN/
IEEE1284 interface
IEEE1284 interface
Keypad is selected*
FEED/LINE
FEED/LINE
FEED/LINE
FEED/LINE
FEED/LINE
FEED/LINE
FEED/LINE
Scanner/ Smart
keyboard is selected*
keyboard is selected*
FEED/LINE
Green light
Off
Three
short
beeps
short
beeps
When the desired mode
is selected, press the
FEED/LINE button for
more than 3 seconds
until both the ON LINE
(POWER) and ERROR
indicator is turned off.
is selected, press the
FEED/LINE button for
more than 3 seconds
until both the ON LINE
(POWER) and ERROR
indicator is turned off.
Off
4
Press the POWER button
to turn off the printer,
then press again to turn it
on.
to turn off the printer,
then press again to turn it
on.
(NOTE: This step is NOT
required for download mode.)
required for download mode.)
5
Printer status
Procedures
ON LINE (POWER)
indicator
ERROR
indicator
Buzzer
Off
One short
beep
beep
Blinking green light
Blinking green light
Off
Three
short
beeps
short
beeps
Off
Red light
Off
Blinking red light
Off
Blinking red light
Blinking green light
Blinking red light
Blinking green light
(longest blink interval)
Blinking red light
(longest blink interval)
Blinking red light
(longest blink interval)
Blinking green light
(longest blink interval)
Off
Press the FEED/LINE
button repeatedly to
select different operation
setting mode cyclically.
button repeatedly to
select different operation
setting mode cyclically.
3
* Keypad and
Scanner/ Smart
keyboard selection is
only available for USB
and RS-232C board
printer. If this selection
is selected, even if the
device is not
connected, other
interfaces cannot be
activated.
Scanner/ Smart
keyboard selection is
only available for USB
and RS-232C board
printer. If this selection
is selected, even if the
device is not
connected, other
interfaces cannot be
activated.
Confirmation of the
selected mode.
selected mode.
(while pressing FEED/LINE)
Completion of function
execution.
execution.
(after release of FEED/LINE)
(except for download mode, in which case
the ERROR indicator will be lighted in red
instead.).
the ERROR indicator will be lighted in red
instead.).
The selected mode will
be valid by restarting
the printer.
be valid by restarting
the printer.
(For download mode selection, the printer will continue to complete the
downloading process. Refer to section 3.6 and 3.7 for details.)
downloading process. Refer to section 3.6 and 3.7 for details.)