Panasonic th-32lru20 사용자 가이드
15
FMA-101 TROUBLESHOOTING PROCEDURES
TROUBLESHOOT THE FMA-101
The following table contains general FTG Basic issues and solutions related to the FMA-101
and the FTG Basic platform.
FMA-101 Troubleshooting
Issue
Solution(s)
The OSD/Call
letters do not
display in the
display in the
guest room(s).
If the issue affects all rooms:
o
Verify the FMA-101 is properly configured.
o
Verify the FMA-101 is balanced flat with the rest of the FTG Basic
platform.
If the issue is restricted to a single room:
o
Wait for the FMA-101 to re-broadcast the channel lineup and re-
test. Note: The amount of time it takes to re-broadcast the channel
lineup is determined by the rate setting that was entered during the
date and time configuration.
lineup is determined by the rate setting that was entered during the
date and time configuration.
o
Check the coaxial connections and signal levels in the room.
o
Replace the terminal.
The date/time is
incorrect.
Reconfigure the Date and Time Configuration in the FMA-101 software
interface.
The laptop/tablet
cannot access the
FMA-101 interface
Verify the laptop/tablet settings are properly configured.
Verify the Ethernet crossover cable is in good condition and connected
properly.
Ping the FMA-101 IP address (10.20.1.128). If the FMA-101 does not
respond, replace the FMA-101.
RESET THE CHANNEL LINEUP
The reset channel lineup function enables technicians to reset or clear all configured channels
from the FMA-101 channel lineup. This function may be used - but is not required - when a
significant number of channels require reconfiguration. Complete the following steps to reset
the channel lineup.
1.
Connect an Ethernet (crossover) cable between the laptop/tablet’s Ethernet port and the
FMA-101’s Ethernet port. Tip: The laptop/tablet’s network settings must be on the same
subnet as the FMA-101.
subnet as the FMA-101.
2.
Launch the laptop/tablet web browser.
3.
Type http://10.20.1.128 in the browser’s address bar and press <Enter>. The Current
Channel Lineup screen will display.
4.
Select the Configure Channel Lineup link. A login screen will appear.
5.
Type panasonic in the User name field.
6.
Type blan in the Password field.