3com WX1200 빠른 설정 가이드
Part No. 10015906
Published June 2007
Published June 2007
M
OBILITY
S
YSTEM
S
OFTWARE
Q
UICK
S
TART
G
UIDE
This document describes how to quickly install and
configure a new WX switch running Mobility System
Software Version 6.0. You can use any of the following
methods to configure a new switch:
configure a new WX switch running Mobility System
Software Version 6.0. You can use any of the following
methods to configure a new switch:
Web Quick Start (WXR100, WX1200, or WX2200)
(see below)
(see below)
CLI quickstart command (see page 7)
You might also need to perform some minor network or
client configuration tasks. See “Preparing the Network
for Distributed MAPs” on page 8 and “Preparing
Clients” on page 9.
client configuration tasks. See “Preparing the Network
for Distributed MAPs” on page 8 and “Preparing
Clients” on page 9.
Using the Web Quick Start (WXR100, WX1200,
or WX2200)
or WX2200)
1
Use a Category 5 (Cat 5) or higher Ethernet cable to con-
nect the switch directly to a PC that has a web browser.
nect the switch directly to a PC that has a web browser.
On WX2200, attach the Ethernet cable to the
management port only.
management port only.
On WX1200 or WXR100, you can attach the
Ethernet cable to any 10/100 port.
Ethernet cable to any 10/100 port.
2
Connect the switch to an AC power source.
If you are configuring a WXR100, do not press the
Fn switch during power on. Pressing this switch on an
unconfigured switch causes the switch to attempt to
contact 3WXM Services instead of displaying the Web
Quick Start.
Fn switch during power on. Pressing this switch on an
unconfigured switch causes the switch to attempt to
contact 3WXM Services instead of displaying the Web
Quick Start.
3
Ensure the NIC of the PC that is connected to the switch
is enabled.
is enabled.
4
Verify that the NIC is configured to use DHCP to obtain
its IP address. You will not be able to access the Web
Quick Start if the IP address of the NIC is statically
configured.
its IP address. You will not be able to access the Web
Quick Start if the IP address of the NIC is statically
configured.
5
Use a web browser to access IP address 192.168.100.1.
This is a temporary, well-known address assigned to the
unconfigured switch when you power it on. The Web
Quick Start enables you to change this address.
unconfigured switch when you power it on. The Web
Quick Start enables you to change this address.
The Web View application on the switch opens in a
browser window. The first page of the Quick Start
wizard is displayed (as shown on the next page).
browser window. The first page of the Quick Start
wizard is displayed (as shown on the next page).
If a certificate check dialog appears, click Accept or OK
to accept the certificate.
to accept the certificate.